stock water filter

  • Lowest Cost Tank Water Filter : multi use water filtration

    0 No Rating Yet

    Lowest Cost Tank Water Filter: complete system with 5 micron sediment filter, 10" housing, housing spanner, mounting bracket with stainless screws, & 1" gate valves. Removes dirt, sand, rust & algae for cleaner water. Use for Rain, Dam, River & Bore water. Lowest Cost Tank Water Filter is "ready to install" complete water filter package with 5 micron sediment filter, mount bracket with stainless screws, 2 x 1" joiner nipples with 1" water valves, plus thread tape. Our Lowest Cost Tank Water Filter removes Sediment and particulates from your source water down to 5 microns. Can be used on rain water, dam, river & bore water for various water filtration requirements. Use as a basic Tank Water house filter, to remove dirt, sediment, sand, rust, algae & organic matter, for cleaner water. Use as a Pre Tank filter for dirty water sources, and reduce sediment added to your tank water. (Install before your water storage tank to act as a pre-filter, removing dirt from water filling the tank). Use for stock water : this lowest cost tank water filter is also an economical solution for better quality stock water. Improve stock health & performance when they drink more water. Features Lowest cost tank water filter Includes 5 micron sediment filter cartridge 10" x 4.5" UV stabilised Big Blue filter housing Rated up to 90 litres/ minimum ( 1" ports ) Complete and "ready to install" with mounting brackets, screws, joiners, housing wrench, 1" inlet & outlet water valves, thread tape, & 5 micron sediment filter cartridge Installation Turnoff water supply from pump. Select best position to mount Lowest Cost Tank Water Filter (after pump & before or at house) –  under cover & out of the weather. Note arrow direction of “water IN/OUT “ ports on top of housing before mounting Lowest Cost Water Filter Connect black joiners to IN/OUT ports in correct sequence ( use thread tape) Cut waterline & connect to IN port of LCWF via 1” water valve Connect other end of water line to water valve at OUT port Remove packaging wrap from filter cartridge inside housing, and carefully use housing spanner to tighten housings back into position. Open house/garden tap (to flush line), turn on pump water supply, and gently open IN water valve. Carefully depress Red Pressure button on top of housing to bleed air until water replaces air. Run house tap for a 5 minutes to flush cartridges, and check for any water leaks. Enjoy good water! (nb A pressure limiting valve must be installed to counter water pressure spikes for town water sources. Also install PLV  if system is subject to water pressures greater than 80 psi.)     Replacement Filter Cartridges are available for purchase here at saferwater.com.au